REFER TO MY DISCOVERY & RIFLE TRIGGER GROUP VIDEOS FOR HOW TO INSTALL & ADJUST THIS FCG

It's a direct fit for all Discovery and 2260 models with a factory wood stock. The slot in the plastic stock for Maximus and Fortitude models needs to be cut or filed 3/8" longer towards the front to fit, this is very easy to do, the plastic is thin in that location.

With a short travel and light pull this group produces fast response and improved accuracy making it ideal for hunting and target shooting. With the thinnest trigger blade in the industry and a larger trigger guard there's a lot more room for adult-sized fingers and gloves. The trigger pull varies from around 5 oz to 4 lbs. depending on how it's adjusted, how much hammer spring tension you have and how smooth your hammer assembly works. The casing is machined from 360 brass. It's not a copy of the original, it's re-engineered to fit and function better. The custom trigger and safety are 7075-T6 aluminum. The trigger return-spring and adjustment set-screws are stainless steel. The custom sear is made of heat-treated 410 stainless steel, it's extremely tough, durable and functions ultra-smooth.

It's shipped ready to mount and use at a safe but very responsive adjustment good for both hunting and target shooting. Further adjustment can cause the gun to fire unexpectedly or not at all, so it should only be adjusted by experienced individuals. A .050" hex wrench or bit (not included) is needed to adjust the travel screws. The top screw adjusts how high the sear rises, this should be adjusted so the safety engages smoothly without binding against the trigger but the trigger should have little to no wiggle-room. The bottom screw adjusts how far down the sear will move, it can be adjusted to limit trigger pull to only what's needed for the gun to fire. Too short of a travel adjustment can prevent the gun from firing when the trigger is pulled. This is a dangerous situation where the hammer is partially released and could fire unexpectedly. To correct this safely, fully-cock the gun and engage the safety. Then adjust the screw away from the trigger until it will fire correctly. Make sure the gun is pointed in a safe direction art all times.

The casing is machined 360 brass with no textured finish or coating. It can be bead-blasted like the one shown in the last two photos, polished or left to age naturally. Over time it will darken slightly for an antiqued look. There may be slight darkening in spots as shown in the main photo when it's shipped.